Troubleshooting common issues with FLECKER control valves

The FLECKER control valve is the main control element of water softening equipment. If it fails, this inevitably affects the water quality in the entire system. Therefore, any problems with the FLECKER control valve should be addressed immediately. Below are some common problems and their solutions:

1. The FLECKER control valve is not working

- Power supply problems: Check the circuit to ensure its integrity.

- Timer malfunction: Reset or reset the timer.

- Water filter clogged: Immediately clean the water filter at the inlet.

- The riser pipe is disconnected from the valve body: Correctly install the riser pipe.

2. Reduced water pressure in the FLECKER control valve

- Scale in the distribution tube: Clean the affected part of the tube.

- Distributor corrosion: Thoroughly clean the control valve.

- Foreign objects in the control valve pipeline: Remove all obstacles in the pipeline.

3. The FLECKER water softening control valve is constantly running or not supplying salt

- Clogged drain control valve: Immediately remove any blockages in the drain control valve.

- Clogged brine injector: Clean the brine injector to remove any blockages.

- Clogged inlet filter: Immediately clean the inlet filter.

4. The FLECKER water softening control valve is constantly running due to setting errors

- Reason: Incorrect settings can lead to a short circuit or open circuit in the switch.

- Solution: If the valve is damaged, replace it. Or try restarting the system once.

By quickly and systematically resolving these common problems, you can ensure the proper operation of your FLECKER control valve and maintain the efficiency of your water softening system.