How to Manually Regenerate a FLECKER Control Valve

Manual Regeneration of the FLECKER 2850 Control Valve  

When the program light is on, it indicates that the program is being input. To switch to manual mode, you must press the program key to return to the working state. When the program light on the display is off, all actions can be manually performed using the ▲▼ keys.  

-For Flow-Based Systems: The manual adjustment sequence is: remaining water volume, backwash, brine draw, slow rinse, fast rinse, and refilling the salt tank.  

-For Time-Based Systems: The manual adjustment sequence is: backwash, brine draw/slow rinse, fast rinse, and refilling the salt tank.  

Mechanical Flow Control Regeneration Type  

 Setting the Flow Rate for the FLECKER 2850 Control Valve  

1. Calculate the periodic water production capacity based on the exchange capacity of the resin filled in the resin tank. Subtract the necessary reserve amount, and the resulting value is the set flow rate.  

2. Pull out the flow dial and rotate it to align the set flow rate number with the white dot on the flow dial.  

3. Release the flow dial, ensuring that the gears mesh properly.  

Note for 2850 Control Valve: After initial installation of the flow meter, the following checks should be performed:  

1. Rotate the manual regeneration valve to run through the program once.  

2. Turn the program wheel or center wheel clockwise to align the set flow rate number with the small white dot.  

3. The set flow rate can be changed at any time.  

 Setting the Time for the FLECKER 2850 Control Valve  

1. Press the red button to disengage the 24-hour time dial.  

2. Rotate the time dial to align the current actual time with the arrow marked "time of day."  

3. Release the red button to re-engage the time dial.  

This guide provides clear instructions for manually regenerating the FLECKER 2850 control valve, setting the flow rate, and adjusting the time, ensuring proper operation and maintenance of the system.